Questions About Resources You Must Know the Answers To

Timber Protection

Wood science is the study of wood as a material that is renewable and of biological origin. In other words, the term wood science can also be known as wood technology. Other products are put alongside wood for easy testing and study. Materials properties, ease of it being worked on and its value are among the few properties which are compared against those of wood and other materials. The many Merits of timber and these technologies improve wood to be superior over other products. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. It is also based on renewable resources. The other merit is that a part of the harvested material is at the same time used as energy to produce the product.

Protection of wooden structure and products is a must if you want to keep the good looks in place. The biggest threat to wood being moisture and insects has to be kept away from the wood. The water particles in the timber increase the rotting and the insects bore through the wood. There are many ways timber is treated among them being the ACQ in other words alkaline copper Quaternary. This is a copper-based preservative that is applied to the wood for protection. Although being a good method to use for wood protection it has presents some few challenges. It has been seen corroding most metals for example aluminum in less than six months of its application. The saturation level of any treatment will depend on where the wood is going to be used and the species of the wood. The concentration level of the chemical will be different for two pieces of wood where one is used above ground and the other close to a water body.

Another wood treating method that is fast being accepted is the use of copper metal. The use of this method is fast being accepted because it is not corroding the metal fasteners. An alternative name to be given to this method is the micronized copper wood preservative method. In this process microscopic particles of solid copper metal are mixed in a liquid carrier and injected to the wood at high pressure. The difference between this method and the other copper-based methods is that the copper is used as a metal rather than a dissolved material. When this process is used to treat timber the timber properties are increased highly. The time the wood products treated using this method last is longer other types of treatment.

Termites and fungal decay are just a few among the many problems wood treated from this method are protected against. It has also shown to be an improvement in corrosion resistant properties to metal fasteners. The wood treated using this method last longer and is stronger.